Runescape Bits & Bytes
https://www.rsbandb.com/forums/

Techy-ish Sig
https://www.rsbandb.com/forums/viewtopic.php?f=32&t=70176		 Page 1 of 1
Author:  Coheddddd [ August 12th, 2008, 2:10 pm ]
Post subject:  Techy-ish Sig
Image

Rate, CC?

:)
Author:  Adbot [ August 12th, 2008, 2:10 pm ]
Post subject:  Register and login to get these in-post ads to disappear
Author:  Flash [ August 12th, 2008, 2:15 pm ]
Post subject:  Re: Techy-ish Sig
9/10...

Very nice. The only thing I didn't like is that the guy in the picture looks a little bit ugly. :|
Author:  Coheddddd [ August 12th, 2008, 2:19 pm ]
Post subject:  Re: Techy-ish Sig
Shoulda seen the other renders :wink:
Author:  Haruki [ August 12th, 2008, 3:11 pm ]
Post subject:  Re: Techy-ish Sig
It looke like you're just starting out so I can't complain to much cause it looks good ;) the only thing that makes it look weird to me is that it looks like you added the "bevel & emboss" effect to try and make a border >.< I wouldn't recommend doing that ;) But ya other than that it's pretty good :D
Author:  Humus [ August 13th, 2008, 6:00 am ]
Post subject:  Re: Techy-ish Sig
Haruki wrote:
the only thing that makes it look weird to me is that it looks like you added the "bevel & emboss" effect to try and make a border >.< I wouldn't recommend doing that ;)

Yeah, listen to Haruki. that point is one I was going to point out. If you just want to do a simple border just use a 1 pixel pencil. Then draw around the sig while holding down shift (straight lines). If you want something more fancy you can always make it thicker and leave out the left and right side. I also think that blending the render by making it more transparent is a definite no-no. :D
One thing I would recommend is having small parts of brushes/C4Ds overlap the render, but not too much as to make it unrecognizable, like I did in this sig:
Image
Page 1 of 1 All times are UTC - 7 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/